Strength limit of the stirring shaft material at the design temperature
Thread Content
This post was last edited by zjq1962 on 2018-10-8 at 14:20. As shown in the attached figure, when using SW6 to calculate the stirring shaft, it is necessary to enter the value of the strength limit of the shaft material at the design temperature; the software does not provide this value automatically and requires manual input. Where can this strength value be found?
Why can’t I open the picture in the attachment?
https://bbs.hcbbs.com/thread-238058-1-1.html This is the previous post; you can take a look