For the connection between the nozzles on a pressure vessel and the shell, is it better to insert them or to have them at the same level?
Thread Content
For the connection between the nozzle on the container and the shell, is it better to insert it or to have them at the same level?
It’s level and good. Because leveling does not damage the pattern of the container body.
This takeover should be related to the purpose and operating conditions, right?
It depends on the location and purpose; if there is no impact, the fitting at the insertion point can serve as a reinforcement
From a force perspective, it’s properly inserted； But due to process requirements or other reasons, it must sometimes be flush with the inner wall.
If it’s a fatigued device, is it better to insert it fully or at a flush level? Are there any relevant requirements?
It cannot be considered solely from the perspective of the equipment; the requirements of the medium must also be taken into account.