What is the current status of the cooler? Is it a problem with the circulating water?
Thread Content
The heat exchanger has been in operation for 3 days since its tube cleaning was completed – is this due to a problem with the circulating water?
Your water is way too dirty; it can be treated in advance.
The cold exchanger developed problems 3 days after operation following tube cleaning; it might be a problem with the circulating water. Circulating water serves to cool the heat exchanger; if it contains impurities, sediments, or deteriorates, it can cause blockages in the heat exchanger, reduce its cooling efficiency, and even damage the equipment. Therefore, it is recommended to check the quality of the circulating water, clean the circulating water system, and replace it regularly to ensure the proper operation of the cooler. .
This is likely due to the poor quality of the water after circulation treatment – there is a lot of sludge, and sedimentation is also evident. Firstly, the disinfection effect is inadequate; secondly, no necessary measures are taken to remove suspended solids from the recycled circulating water
It’s possible that the temperature of your heat exchange medium is too high.
It didn’t run. It’s just the circulating water in circulation.