What do a and b in the heat exchanger stage partition refer to respectively?
Thread Content
As shown in the figure, there is a partition plate in the tube side of a double-pass heat exchanger: one side of this partition plate is welded to the head, while its other two sides are welded to the sides of the shell; one section of it is connected to the tube sheet via gaskets. I would like to ask everyone the following: 1. In the \"partition plate structure type\" for SW6, should we choose the option of \"three sides fixed, one side simply supported\"? 2. Which data do a and b represent respectively?
So, in this “partition structure type,” should one choose “three sides fixed, one side simply supported”?
So, in this “partition structure type,” should one choose “three sides fixed, one side simply supported”?
If the long side is fixed, how do I enter the values for the short side that is simply supported?
When the tube sheet has a flat cover instead of an end cap, it is divided into long sides and short sides