Seeking advice on the selection of heat exchanger types
Thread Content
The operating conditions are as follows: the acetic acid solution is at 192°C, with a pressure of 3 MPa and a flow rate of 300 t/h; it enters the heat exchanger to heat the deionized water at room temperature. The flow rate of the deionized water after heating is also 300 t/h, and this heated water then enters the reactor to generate steam for use in the turbine. May I ask what type of heat exchanger everyone should choose to achieve the best results? Thank you!
This issue is too complex and requires consideration from multiple perspectives
If this is overlooked, your steam engine will be in trouble
I want to use a plate exchanger; the possibility of mixing is very low, and there is a leakage tray
Plate heat exchangers offer good heat transfer efficiency, but you need to generate steam
Steam generation passes through the reaction vessel, with liquid-liquid heat exchange in the heat exchanger
If you’re worried about leaks, there are double-sheet plate heat exchangers, and shell-and-tube types are also quite stable.