How to adjust the arrangement of pipe sections?
Thread Content
Inside the process package, it’s in the format 3421. After trying for a long time on my own, I was only able to get it to take on the format 4312. I would appreciate it if someone could advise me on how to adjust it so that it matches the format shown in the first image. O(∩_∩)O Thank you. The htri file is attached
This has no impact on htri
Symmetry indeed has no impact. But it’s obvious from the first image that it’s an HTRI diagram; I’m quite curious about how the settings in the process package result in something like this
Hello, I took a look – the second piping method is the type available in 6.0, while for the first piping method you can choose it in 7.0 Geometry–Tube Layout–First tubepass location.
It really is. . . 7, just run it like this. Thanks, haha