What is the groove depth value for the tube sheet side structure?
Thread Content
I have a question for the experts here: what should be the appropriate depth of the grooves in the tube sheet side structure? As shown in the diagram, should it be set at 3 mm? I hope the expert can give some advice. Thank you
There is a problem with the thickness difference between the tube sheet and the flange
If there are any issues, please let me know. Thank you
If the groove depth at the split point of the tube sheet is 5 mm, then shouldn’t the difference in thickness between the tube sheet and the flange be 65 – 5 – 51 = 9 mm? Please advise, expert. Thank you
It’s not calculated this way; the depth of the partition groove should not be deducted!
It’s just the value of 65-51; there’s no need to subtract the depth of the grooves anymore. When the thickness of the tube sheet is unknown, it is 3+6+5=14
Is the groove depth value on the tube sheet side 3 mm? Looking forward to your advice. Thank you
The tube side is 5, and the shell side is 3
The dimensions of this node diagram are listed in Appendix 151