Thread Content
1. Product Introduction Ball Parker packing is also called Q-pa Parker, three-plus-one high-efficiency plastic packing for scrubbers. The unique dropping point design of Ballpa Parker's packing allows the turbulent flow structure of the gas to create tens of thousands of small droplets, which can exponentially increase the gas-liquid contact area with minimal resistance to gas passage. Ball Parker packing can provide the most efficient mass transfer with small pressure drop, and can provide high-quality mass transfer efficiency on the basis of lower initial setup, operation and maintenance costs. The product has achieved satisfactory results in packed towers such as wet scrubbers/gas stripping towers and has the following advantages: 1. Its structure uses dropping points and gas turbulence to create millions of small droplets, increasing the gas-liquid contact area with small air flow resistance. Provides efficient mass transfer and low pressure drop. 2. Lower pressure drop, requiring less wind energy, saving energy costs, 30-50% higher processing capacity, anti-structural clogging, good anti-scaling ability, evenly spaced rod-shaped design of the product, sleek appearance structure and high void ratio, self-cleaning function can minimize clogging, which means reduced maintenance times ； 3. Allows for higher empty tower flow rate design, small equipment tower diameter and small floor area ； 4. High mass transfer efficiency, low filler height required to achieve the same efficiency ； 5. High void ratio, reduced pressure and low fan energy consumption ； 6. Excellent anti-scaling and anti-clogging properties ； 7. After operation, the packing will not overlap each other, reduce efficiency or produce short flow. ； 2. The main materials of the product. The current main materials of our company's ball parker fillers are PP polypropylene, PPH polypropylene, PVDF polyvinylidene fluoride, RPP reinforced polypropylene and other materials. Ball parker plastic fillers made of other materials can be manufactured through negotiation between the supplier and the buyer. 3. Product application Plastic ball Parker packing products are suitable for filling tower materials in large scrubbers, gas absorbers, and gas cooling towers. Its low pressure drop (packing factor of 7/ft) opens up a new possibility in the design and upgrade of packed towers. Its flow structure uses drop tips and gas turbulence to create countless droplets, exponentially increasing the gas-liquid contact area while minimizing the obstruction of the air flow. Its porosity is very high, up to 96.3%, and its uniform spatial network structure allows fine solid particles to pass smoothly without clogging it. These advantages of scrubbing efficiency, air flow capacity and anti-clogging ability are unmatched by other tower packing materials in the world.