Seeking help with equipment drawing
2023-09-11View Original
Thread Content
Does the drawing method inside the red circle refer to making a small hole?Related Threads in This Forum
← Previous
- How can a belt conveyor be made more wear-resistant? - HCBBS
- How to properly use a high-precision grating length measurin
- Is pure titanium (TA1, TA2) sufficient for petrochemical equ
- Introduction to Metal Mesh Belt Conveyors - HCBBS Forum
- Selection of welding electrodes during welding - HCBBS Forum
- Use of horizontal spiral centrifuges - HCBBS Forum
- Understand the application scope of conveyor rollers - HCBBS
- How thick is the flower plate of a bag filter usually? - HCB
- This seems to be a bearing; does anyone know what brand or t
- A brief discussion on the important role of chain plates in
Next →
- Standard drawings and measurement methods for diaphragm asse
- What is a centrifugal compressor? - HCBBS Forum
- 【Video】09. DIY wire stripper (available upon reply) - HCBBS
- Filter element size confirmation - HCBBS Forum
- Amazing mechanical principles – modern vegetable cutting mac
- Did anyone take the registration exam for equipment engineer
- Piping requirements and recommendations for sewage pumps - H
- Calibration method for sheet width measuring instruments – M
- Channel steel, H-beam, load-bearing - HCBBS Forum
- Analyzing stainless steel unpowered rollers - HCBBS Forum
Translated at 2026-07-26 10:09:11
Original: https://bbs.hcbbs.com/thread-4887828-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.