How does CADWORX define parameters such as pipeline design pressure and design temperature? ? ?
Thread Content
The question is as stated in the title. Regarding how to create single-line diagrams, after some research it was found that if parameters such as the design pressure and temperature of pipes need to be indicated on the diagram, the PIPELINE ATTRIBUTION function can be used. However, it is necessary to create an ATTRIBUTION file oneself, which serves as a database for ISOGEN to use. Creating such a file is quite troublesome; at least 9 parameters are required for each pipe... and it has to be edited using Notepad. Is there any way to enter this data while modeling pipes in CADWORX, so that these parameters are directly reflected in the PCF file by the software, allowing for easy reference? ? ? ? ? ? Is there any other way? ? ? ? ? Just add the parameters
May I ask where this PIPELINE ATTRIBUTION is located, OP?