Aspen issue
Thread Content
Does anyone know how to solve this problem? The kinetic coefficient values are entered correctly, but this problem persists. Increasing the feed flow rate is also useless
Is the unit correct? It would be best to upload the file for a look
That’s the problem in this file; it just can’t be solved. Please help me take a look, senior
Your version seems to be too advanced; I can’t open it
This is version 8.4; could a senior please take a look?
Just by looking at your kinetic data, it’s not easy to tell much, but I changed the flow rate of hydrogen, and the amount of product still changed. Take another look: is the unit for the activation energy kj/kmol, and is the pre-exponential factor k equal to 0.00092? Also, I see that you have specified T0, but at the same time you set n=0; doesn’t that mean that T0 is effectively not specified? Isn’t (T/T0)^n equal to 1 in the case of n=0?
T0 is used to calculate K! There are two ways to express this kinetic equation! I know that changing the amounts of hydrogen and solid feedstock affects the quantity of product, and no serious errors occur as a result, but the problem mentioned at the beginning still persists
T0 is used to calculate K! There are two ways to express this dynamic equation! Look at its formula: it is (T/T0)^n. What I mean is that T0 isn’t really necessary, because if n is set to 0, then (T/T0)^n will always equal 1. By the way, what was the question you mentioned initially? I didn’t see it
The original problem is this diagram. It just can’t be solved; the dynamics should be fine