An error has occurred in the flash module
Thread Content
A problem occurred during the simulation calculations: the FLASH CALCULATION reduced the temperature to the lower limit of 97.0950 degrees K, but the enthalpy balance was still not satisfied. The heat duty specifications may be unattainable. Property calculations cannot be carried out due to this FLASH failure. Please, experts, help analyze what this means and how to resolve it Special thanks, thank you very much
There is a problem with the FLASH settings; perhaps the phase of the logistics cannot be achieved under the set conditions. Can you extract your settings and logistics information?
Carefully check the settings and units, and pay attention to the critical state of the fluid; below a certain pressure, it cannot be liquefied no matter how low the temperature is
I encountered the same problem. Has the original poster found a solution?