Thread Content
This post was last edited by *amingteda on 2017-8-31 at 22:50. Dear marine friends, in order to help everyone learn the *ProII process simulation software better – so that beginners can gain knowledge and experienced users can refresh their skills – we are launching a series of activities titled “Make Progress Every Day” for learning the basics of ProII. Since I primarily use Aspen Plus/Hysys in my work, I have not studied ProII software systematically; therefore, the knowledge I offer might be quite basic. I hope fellow users will provide valuable suggestions and opinions, and actively participate in the discussions. Multiple-choice question: 8. Which of the following statements about the reboiler in the PROII distillation column is correct? A. The type of reboiler can be chosen from three options: kettle reboiler, thermosyphon reboiler, or no reboiler. B. Kettle reboiler: The gas phase leaving the reboiler is in equilibrium with the liquid phase at the bottom of the tower; therefore, the kettle reboiler can be considered as an equilibrium stage of the tower ； The disadvantage of such reboilers is their high cost. C. Thermosiphon reboiler: utilizes the density difference between the material at the inlet and outlet to drive its flow; single pass, considered as 1 equilibrium stage ； Cycle: 2 balancing stages are required for simulation ； Selectivity requires 2 balancing stages for simulation. D. One-way thermosyphon reboiler, 1 tray, with or without baffle plates ； Cycle *******: 2 trays, no baffles; it features a relatively simple structure and is easy to control ； Selective *******: 2 trays with baffles, which improves tray efficiency while maintaining a simple structure and ease of operation. Reference answer: ABCD