Orientation of heat exchange tubes in the HTRI air cooler (see attached diagram)
Thread Content
Dear Haichuan friends, when performing calculations for AIR Coolers and Economizers at HTRI, the Orientation options include horizontal, vertical with top feed, and vertical with bottom feed. Select Horizontal, Vertical Jacking from the top, and Vertical Jacking from the bottom in sequence; after operation, there was no change in the performance results, nor was there any change in the 3D diagrams in the Drawings. What are the main functions of these three options?
The calculations for air coolers and economizers are actually the same. If an economizer is to be used, flow should occur from top to bottom; choosing different inlet and outlet positions has an impact on the calculation structure
OP, has this issue been resolved?