Problems encountered when using the Aspen Energy Analyzer to optimize heat exchange networks
Thread Content
Dear experts, I have been learning the *Aspen Energy Analyzer software recently. While reading its instructions, in Chapter 6 on optimizing heat exchange networks, the manual suggests clicking the settings button and then the \"Modify Utility Heat Exchanger\" icon; however, I cannot find this button. Did I make a mistake somewhere? Please give me some guidance. Thank you!
Waiting online – please, some expert can help answer this question
There is a series of icons on the heat exchange network diagram, and one of them is the \"modify utility heat exchanger\" icon, which is used to modify the flow streams
I’ve found the cause – it’s a version issue. I’m using version 7.2, while version 10.0 has this button. Thank you everyone!
Thank you. I checked and found that version 7.2 doesn’t have these icons, while version 10.0 does. I installed version 10.0, and when I click the button, I get the message “The network topology cannot yield a feasible design”. Please help me figure this out
I’ve uploaded my example; please help me take a look, experts
Where are the attachments? Why wasn’t it uploaded? Let’s try again
I’ve never used attachments – why is wealth the default setting?