【Process Engineering Division – Chemical Engineering Software Forum – Daily Question – Questions 03–16】
Thread Content
【Process Engineering Section – Chemical Engineering Software Forum – Daily Question – Questions 03–16】When drawing circles in AutoCAD using the tangent, tangent, tangent method: (A) The objects that are tangent must be lines. (B) It is not necessary to specify the radius and center of the circle. (C) Activate the circle-drawing command from the drop-down menu. (D) The center does not need to be specified, but the radius of the circle must be entered. Note: Questions are valid only on the day they are posted (3 correct answers and 1 wrong answer; posts filled with irrelevant content will be deleted). Replying extensively to old posts is considered posting spam, and such responses will not earn any points or may be awarded points at the discretion of the organizers. 2
(B) It is not necessary to specify the radius and center of the circle.
(B) It is not necessary to specify the radius and center of the circle.
B) It is not necessary to specify the radius and center of the circle