【Process Engineering Division – Chemical Engineering Software Forum – Daily Question – Questions 03-29】
Thread Content
【Process Engineering Section – Chemical Engineering Software Forum – Daily Question – Questions 03-29】In AutoCAD, an inscribed polygon is defined as ( ). A. The polygon is inside a circle, with the midpoints of each side of the polygon lying on the circle. B. The polygon is outside a circle, with the vertices of the polygon lying on the circle. C. The polygon is inside a circle, with the vertices of the polygon lying on the circle. D. The polygon is outside a circle, with the midpoints of each side of the polygon lying on the circle. Note: Questions are valid only for that day; 3 correct answers earn points, 1 incorrect answer results in disqualification. Replying to previous posts in large numbers is considered spamming, and such responses will not earn any points or may be given points at the discretion of the moderators. =4-1
D. The polygon is outside the circle, and the midpoints of each side of the polygon lie on the circle
C. The polygon is inside the circle, with its vertices on the circle
C. The polygon is inside the circle, with its vertices on the circle