Thread Content
When using CAD mobile software to view CAD drawings and it is necessary to draw straight lines or multiple line segments, one usually selects existing graphic grips to do so. But if the exact coordinates of each point are known, how can the corresponding line segments be drawn by connecting those points? Next, I’ll give you a brief introduction to the tutorial on how to draw line segments using known coordinate points in the CAD mobile viewing software Haochen CAD ViewKing! To facilitate users, the HaoChen CAD ViewKing mobile version provides a function to directly enter coordinate points for drawing line segments. The specific steps are as follows: First, open the Haochen CAD ViewKing mobile version, then select the single segment or multiple segments function. Click anywhere on the screen, and after that click the x,y button; this will bring up a screen for entering the x and y coordinates. On this screen, you can enter the actual x and y coordinate values as required. As shown in the figure below: after entering the values, click the checkmark button in the lower right corner to confirm, then click somewhere else on the screen; at this point, click the x,y buttons again to enter the coordinate values for that point. Repeat the above steps, entering each coordinate point one by one, to connect the points into line segments. As shown in the figure below: The above are the detailed steps for drawing lines based on known coordinate points using the CAD mobile viewing software HaoChen CAD ViewKing. Everyone can refer to this CAD tutorial when encountering similar problems in future use~