Dynamic simulation of screw compressors will not run; please advise, experts
Thread Content
I’ve been learning dynamic simulation using *HYSYS lately, and I decided to start with something simple. I created a process for a screw compressor, adjusting the position of the slide valve based on flow rate, but nothing happened when I ran it. I’ve attached the source files; if any expert has time to offer some guidance, I would be extremely grateful:handshake
You haven’t set the feed flow rate, right? The position of the flow control slide valve is adjusted, but nothing happens when it’s in operation – is there some setting you need to adjust?
In the upper left corner of the folder, there is an option labeled “View”; check the file extension to enable editing
When I checked on my end, there was no data usage shown; after making changes, it worked. You want to adjust the position of the slide valve based on flow rate. There are no special settings in your model; it can simply operate dynamically.
Could you give me the modified file so I can study it? Expert: lol