How can EDR adjust the baffle while preserving the e*sting layout

Thread Content

Currently, the heat exchanger was adjusted using the e*siting layout method to modify the piping diagram, and the calculation results are fairly satisfactory; however, it is believed that increasing the number of baffles could yield better results. Therefore, the number of baffle plates was increased and their spacing was adjusted; the number of baffle plates changed from even to odd, and the nozzles were moved from opposite sides to the same side, while attempting to reduce the circularity of the baffle plates. After clicking Run, an error is reported stating that the nozzles do not match the piping diagram. At this point, if you switch to other options such as new, optimum, or new, match pass, or new, match tube count, the nozzle-related errors will disappear; however, the piping layout that was carefully adjusted earlier will be lost, and the newly generated piping layout may not be able to be adjusted to match the previous settings. How do you handle such situations?