There are issues with the beginning and end
Thread Content
This post was last edited by 2005180005 on 2024-5-22 06:34. As shown in the diagram, there seems to be an issue with the flow direction of this pipeline – everything is flowing out; it should be one outlet and one inlet instead. As a result, it’s not possible to add matching flanges at the pipe ends, and any flanges added end up being created elsewhere. What is wrong with the settings? How to operate it?
It might be that the flow direction of the pipeline is set incorrectly, or the connection points of the pipe ends are set wrong. You can try resetting the flow direction of the pipeline and ensuring that the connection points of the pipe ends are correct, before adding the flanges. If the problem persists, you can check if there are any software updates or consult technical support. .