Paid assistance regarding HYSYS simulation of CO2 absorption by MEAs
Thread Content
I have now set up the absorption/desorption process, and the circulation rate has been determined; however, the temperature in the absorption tower is too high, and the absorption efficiency does not improve even after circulation. Seeking guidance for a fee.
Possible solutions include reducing the temperature of the circulating fluid, adjusting its flow rate or concentration, and checking for blockages or damaged trays inside the absorption tower. It is recommended to check and optimize these parameters to see if they can improve the absorption effect. If the problem persists, it is recommended to further analyze the specific components of the feed gas and circulating liquid, as well as the operating conditions. .
Try reducing the gas-liquid ratio, that is, by increasing the liquid flow rate and feed temperature