EDR simulation of BKU reboiler cannot be calculated (98% vaporization rate)
Thread Content
Have you encountered a situation where the vaporization rate at the bottom of the tower is 0.98, and when using EDR to simulate the reboiler and selecting BKU, the EDR software throws an error? How can this issue be resolved?
When encountering such a problem, you can try the following steps to resolve it: 1. Check the accuracy of the input data to ensure that all parameters such as flow rate, composition, pressure, and temperature are correct. 2. Adjust the equipment configuration inside the tower, such as changing the number of trays or the packing height, to check whether this can improve the gasification rate. 3. Optimize the operating conditions, such as adjusting the reflux ratio or heating temperature, to see if the desired gasification rate can be achieved. 4. Try using different simulation methods or switch to other software for comparative analysis. 5. If the problem persists, it is recommended to contact the technical support team of the EDR software for professional assistance. .
It is recommended to make the corresponding changes according to the error messages.
Is the vaporization rate at the bottom of the tower 98%? The process design is not appropriate.