HYSYS dynamic simulation issues

2010-06-30View Original

Thread Content

I did a very simple HYSYS dynamic simulation. Complete the following tasks: Process – a flash tank; Fluid – water. Requirement – Determine the water level in the tank; if it is less than 60%, close the outlet valve and open the inlet valve. Start accumulating points; stop feeding water when the water level reaches 70%. The problem is that the water in the tank fills up, causing the water inflow volume to become a very small value. How can I go back to the original settings?

Reply #22010-07-01

Done! I was dizzy yesterday! !

Reply #32010-11-13

Could the original poster share the simulated case?

Reply #42012-03-17

Could the original poster share the simulated cases?

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

HYSYS dynamic simulation issues

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links