[Daily Question] [Static Equipment Exchange Edition...Question 111] Adapted multiple choice question on April 21, 2019...all the best

Thread Content

This post was last edited by kareale88 on 2019-4-22 08:26 bg4.png [Daily question] [Static Equipment Exchange Edition...Question 111] Adapted multiple-choice question on April 21, 2019...All the best......................................................................The question comes from the book: I hope everyone will point out the lax adaptation of NB/T 47041-2014 "Tower Container". If you have good suggestions, you can also reply with comments and no hesitation will be rewarded. .................................................................................... Please fill in the answers (single choice, single choice, single choice) in order. Bonus rules: Participation will reward 1 wealth, and correct answers will reward 3 wealth for each item, with a maximum of 10 wealth. ....................................................................1. NB/T 47041-2014 8 Manufacturing, Inspection and Acceptance stipulates the overall dimensional deviation of metal tower vessels and the technical requirements for tower vessels delivered in pieces and sections. Other requirements related to manufacturing, inspection and acceptance should comply with the relevant provisions of GB150.4. ()A. Made of metal ； B. Steel ； ---------------------2. The allowable deviation of the roundness of the tower vessel cylinder is in accordance with GB150.4. () A. Correct ； B. Error ； ---------------------3. The allowable deviation of the distance from the flange surface of the tower vessel nozzle to the outer wall of the tower shell () mm. A.±2 ； B. ±2.5 ； C.±3 ； ---------------------Answer: (Inspection of the manufacturing, inspection and acceptance of tower vessels) 1. B (Specifies that the manufacturing, inspection and acceptance requirements for steel tower vessels and tower vessels made of other metal materials are in accordance with relevant standards. ) 2.A 3.B