Desulfurization design
Thread Content
The water-coal slurry outputs water gas, with a hydrogen sulfide concentration of 2000 mg/m3 at the inlet; the processing capacity is 300 Nm3/h. I would like to ask my colleagues which desulfurization process would be suitable and most cost-effective
Can such a high level of hydrogen sulfide be ensured in the dry process? Are there any recommended manufacturers?
This post was last edited by goldliyang on 2019-11-14 at 11:24 – is it DDS desulfurization?
Your concentration is high, but with a low gas flow rate, there’s no major issue; we can achieve rates of over 100,000 cubic meters per hour