Expert advice needed on temperature and pressure compensation for steam flow rate
Thread Content
Why is a multiplication module used for pressure and temperature in advanced systems? What is the value of this multiplication factor, and what is the basis for it? What would happen if multiplication were not used?
Thermo-pressure compensation responds to density.
The purpose of multiplication is to convert half-precision floating-point numbers into full precision floating-point numbers for computation, with 4000 representing the range of the traffic volume； 300 is the temperature range. Multiplication yields the actual value, which is used in the compensation calculation.
Because the data in the control unit is represented in half-precision floating-point format using values from 0 to 1; these values are then converted to floating-point numbers to obtain the actual pressure and temperature readings
This needs to be compensated by converting to standard units. It’s impossible not to convert