How to use the delay function of Tricon1131?
Thread Content
The compressor unit experiences significant surge during startup, which causes it to shut down before it can operate properly. The surge lasts for 5-10 seconds; after that period, the unit returns to normal operation. Compressors from Shengyu are being used, and all process requirements call for the addition of a delay function. I’m new to the Tricon system and am not yet familiar with how to use its functional blocks. I would appreciate it if experienced professionals could explain in detail how to use these functional blocks and how to make the necessary settings
IEC61131-3 is a general-purpose programming language that is independent of TS3000. Zhao Duniang will ask.
Surge on its own shouldn’t cause the unit to stop, right? I remember that surge itself has a correction block, which increases the margin by 2% each time it enters the surge zone.
This post was last edited by chensf123 on 2018-6-4 18:35. Does it experience heavy vibration and shutdown at startup? The usual approach is for the program to use multiplication. Check the event logs to determine the cause before taking action.