Zhejiang University Zhongkong JX-300XP real-time monitoring software communication failure, please help as shown in the picture
Thread Content
The picture is the information prompted by the real-time monitoring software. You can download the program into the configuration software, but the real-time monitoring software cannot communicate. The IP address of my computer is set to 128.128.1.129 It is the engineering station, and the IP address of the main control card is 128.128.1.2
By the way, he also prompted that the registration record failed.
Have you downloaded the program to the master card and released it? You can check the network and ping the addresses of each computer to see if there is any connection.
You can also check the status of the main control card. The main control card should be redundant. If not, try cutting another piece.
First switch the main control card to see if it is normal, and then ping the controller to see if the network is normal.
There is no redundancy in the main control card. There is only one single card. The red light on the main control card kept flashing. It turned out that it was not flashing. This afternoon, it started flashing when I turned on the computer.
The address published to the local machine is ok, but the address sent to other addresses fails to be published.
Hello, what does ping mean? There is only one main control card in the control cabinet.
Check whether the computer can communicate with the controller normally
The network is not working, please check the network