Fisher DVC6200 Double-Acting Positioner
Thread Content
When using the Fisher DVC6200 double-acting actuator in single-acting mode, is there anything that needs to be set? Excuse me
The Fisher DVC6200 double-acting positioner requires no special settings when used in single-acting mode. This locator has two pneumatic actuators, one for opening and one for closing the valve. When only one actuator needs to be used, the other actuator remains closed, without affecting the single-acting control. Therefore, when used in single-acting mode, only the required air supply and control signal need to be connected, with no additional setup required. .
Relay type, select A for single-acting mode
Oh, when we use the double-acting version in single-acting mode, the automatic verification keeps failing; we have to adjust the DIP switches on the amplifier in order to get it to work.
There’s no separate option A, right? Only AorC and B
Doesn’t the amplifier have only one ventilation volume adjustment screw? What is a DIP gear? :(Am I falling behind?
Just turn the amplifier gear a bit to block one of the holes
Just turn the amplifier gear a bit to block one of the holes
When in double-action mode, if it is in single-action mode, the dial above must be adjusted until the pointer of the small gauge at the bottom reaches 0