Seeking help with Zhejiang University Zhongkong PTCOMPX module
Thread Content
Need help with the temperature and pressure compensation module of Zhejiang University’s control system? In the operating parameters section, should pressure be entered as gauge pressure or absolute pressure? Is the temperature at the input pin of 0°C and the pressure of 0.1 MPa referring to the zero point? I would also appreciate the advice of the experts.
I haven’t used the 700 model, but I’d like to share my opinion. It converts your current conditions – volume flow rate, pressure, and temperature – into values under standard conditions (1 atmosphere pressure, 20 degrees). The IN value represents the actual measured values, whether it’s the volume flow rate, pressure, or temperature. The first graph is just example data and does not come from sensors.
In the temperature and pressure compensation module of Zhejiang University’s control system, absolute pressure is usually required as the input for pressure. A temperature of 0°C and a pressure of 0.1 MPa at the input pin generally refer to the zero-point calibration values of the device. If you have any questions, it is recommended to consult the product manual or contact technical support for more accurate information. .