How to set up the E+H radar, the rod type one.
Thread Content
This post was last edited by batawfn on 2021-3-30 at 19:06. Initially, the length of the poles designed by the design institute was too short; it was increased later. How to set it inside the table again. The radar models used by E+H are FMP51/52/54. For example, if the height of the tank is 3000 MM and it is a horizontal tank, I would like to ask the experts: is it necessary to reset the length of the rod? Empty mark: 3000MM, Full mark: 2800MM. Where should the length of the remaining rod be set?
Wait online until 12 o’clock; I have to go to the location tomorrow and cannot bring my phone.
This post was last edited by Gu Yu on 2021-3-31 15:37
Refer to the manual at http://www.jinhewater.com/PDF/Levelflex/FMP50.pdf; the length of the rod is fixed, so it generally does not need to be set
This post was last edited by gaiyin47 on 2021-4-1 at 16:57. There is no need to set the rod length; just use the empty mark and the full mark.