Regarding the wiring of the Siemens 6ES7134-6GF00-0AA1 module
Thread Content
This post was last edited by Erhu_S8hBe on 2025-1-26 at 14:11. Wiring of the 6es7134-6gf00-0aa1 module: I have a four-wire flow meter; it currently has an external power supply, and I want to connect it to a PLC. I’m not sure how to do this – specifically, I need to connect the current output from the flow meter to the PLC
The Siemens 6ES7134-6GF00-0AA1 is an analog input module, primarily used to receive sensor signals. For your four-wire flow meter, there are usually two power lines and two signal lines. 1. First, verify whether the power requirements of the flow meter match those provided by the PLC. 2. Connect the two power supply wires of the flow meter to the corresponding power sources. 3. Connect the two signal wires to the corresponding input terminals of the 6ES7134-6GF00-0AA1 module. Select the correct terminal on the module based on the type of output signal from the flow meter (e.g., 4-20mA or 0-10V). 4. Configure the channels of this module in the PLC software to properly read the signals from the flow meter. It is recommended to consult the manuals for the flow meter and PLC module to ensure proper and safe wiring. If you are not familiar with electrical wiring, it is best to have a professional electrical engineer carry out the work. .