Is it necessary to check the dynamic stability for 5×6 square millimeter incoming cables?
Thread Content
Is it necessary to verify the dynamic stability for 5×4 square millimeter incoming cables? The drawing review center requires verification of both dynamic and thermal stability; I think thermal stability verification is indeed needed. As for dynamic stability, I read in the textbook that cables have good mechanical strength, so there is no need to verify dynamic stability. How should I reply to the expert?
The drawing review center should provide it to him; it’s beneficial for the design institute to do the calculations – it’s very simple. Generally, large-scale plant design institutes will provide the calculation parameters for cables of specifications such as 5(4)×4 or 5(4)×2.5, but not all of them.
I work at a design institute: Q. The electrical load consists of lighting in the factory building, fans, and electric window openers; in total, it’s only a few kilowatts. I’ve never calculated it before
In my opinion, the requirements put forward by the review center are unreasonable. After all, as a department, they must have some comments for review; since you’re from a design institute, just do the calculations for them – it’s a matter of a few minutes
Well, I need to study this area of knowledge carefully*
What is the significance of verifying the dynamic stability of cables? Will it cause damage to the fixed bracket? That’s too much; it’s completely trying to find fault
Cable selection calculation is one of the items, with clear descriptions provided in the specifications
I’m simply uninformed; could you please specify which standard and which clause outlines this requirement to verify dynamic stability? That way we can learn from it*.
There is no need to verify the dynamic stability of the cable, definitely! :)
Drawing review center, hahaha, what kind of crappy organization is that!