Gasoline hydrogenation heating furnace
Thread Content
The heating furnace does not have sufficient heat load. If replacing the burner. Do we also need to consider the arrangement of the furnace tubes?
What’s needed is actually a complete set.
Since it’s from the same manufacturer, I’ll communicate with the design institute; it would be problematic if I tried to replace it myself. I’ll follow the advice of the manufacturers and the professionals at the design institute~~~
We replaced a burner before. By how much is the furnace temperature higher than before? Low in the radiation section. The heat transfer effect is not very good. Again, I think all aspects need to be taken into consideration
So it is necessary to find a professional agency to recalculate it~~~
It’s difficult, and efficiency will decrease as well.
At first, the feed temperature couldn’t be increased while driving the machine; later, a larger burner was installed, and things improved significantly