Pump lubrication equipment
Thread Content
A new lubrication system has now been installed on the pump, as shown in the diagram. What is the small container indicated by the red arrow? What is its function? And what is the process for the lubricant to enter and exit? Thank you, extra points
This is the PLAN53B sealed flushing system; the red arrow indicates the bladder accumulator, which provides pressure to the 53B system.
How is pressure applied? Could you give some details? What principle
The rinse liquid used in Dandong cloning is generally of the type with low inlet pressure and high outlet pressure
Accumulator, for stabilizing oil pressure; those with a pressure gauge are for the inlet, and those with a thermometer are for the outlet
Inside the accumulator there is a rubber bladder filled with nitrogen; when oil is pumped in, the bladder compresses, and when the oil pressure drops, the bladder expands to replenish the oil
Same principle as the pressure stabilizing tank in a circulating water system
Accumulator, for stabilizing the hydraulic pressure of the isolation fluid; those with a pressure gauge are for the inlet, and those with a thermometer are for the outlet
This is a reservoir filled with nitrogen. The principle is that the air bag inside compresses to release nitrogen, and then it expands to allow nitrogen to enter again, and this process repeats itself