The two-position three-way manual valve at the pyrolysis gas compressor oil station is stuck
Thread Content
During the operation of the pyrolysis gas compressor oil station, after the emergency oil pump had been running for 40 minutes, it was not possible to switch the filter at the outlet of that pump; the two-position three-way manual valve was stuck. Once the temperature dropped to normal levels in the afternoon, the valve was able to operate properly. I’m asking experts: what is the cause of this problem?
The valve core became too hot, which prevented it from switching; the gap inside wasn’t adjusted properly.
Yes, I think so too. I don’t know what’s going on:(
It is estimated that at high temperatures, the sealing material expands and gets stuck to the valve core, making it difficult for the valve core to move