Dalian Imperial canned pump clearance problem
Thread Content
Is the 0.4~0.6 here a single side gap or a total gap? Does anyone know? Thank you. I have just joined the chemical industry circle. Thank you all seniors.
Total clearance, inner diameter of housing orifice ring minus outer diameter of impeller orifice ring
Friends, which source does the picture come from? Can you share it?
This list data should be complete with a view description. Unless otherwise stated, I do not agree with this total gap.
It's hard to say, where did your numerical table come from? I have never seen a similar label in Empire, please check again. Generally, the shielding sleeve and shielding sleeve (between the stator and rotor in the motor) are 0.5mm on one side. What is the gap value? It's really not clear
It's hard to say, where did your numerical table come from? I have never seen a similar label in Empire, please check again. Generally, the shielding sleeve and shielding sleeve (between the stator and rotor in the motor) are 0.5mm on one side. What is the gap value? It's really not clear