Is there a suitable pump for an alloy aqueous solution at around 270°C and 10 MPa pressure, containing about 10% solid particles?
Thread Content
Is there a suitable pump for an alloy aqueous solution at around 270°C and 10 MPa pressure, containing about 10% solid particles? Looking for recommendations
Are there specific operating conditions and performance parameters? If it can’t be given, this question can’t be answered
With a budget of 2.7 million and a family of 5 including 2 children, is there any suitable house? Looking for recommendations; the poster’s request is exactly the same as this one:lol:lol:lol:lol:lol
Process parameters before and after, flow rate, head.
For high-pressure ash water pumps, the impeller should be of the open type, and the flushing water for the pump’s seal must be more than 100 kilograms per unit time. That’s fine
Shielded pump with backwash structure. Temperature and pressure can be easily addressed, but for solid alloy water, what material should be used for the rotating components requires further discussion