Equipment manufacturing workshop. How is the flaw detection room arranged? ? ?
Thread Content
Equipment manufacturing workshop. How is the flaw detection room arranged? ? ?
It’s up to you to arrange it; there are no special requirements
It’s better to build a house made of pure concrete. Is a concrete structure with lead sheets better?
We use pure concrete with a thickness of 700 mm; the main consideration is cost-effectiveness. The lead plates can be removed later and sold for money!
Was the door fitted with lead sheeting, and did you put it on yourself? ? ?
We made 13 thick ones by ourselves; I heard it took 20W to make this door
No wonder it’s so expensive; is the room for developing and viewing photos also in Phase 1?
Made of lead plates and concrete, the flaw detection room usually has a small door for connecting to the control room. In the manufacturing plant where I used to work, film developing and evaluation were both done in the control room, as it was large enough to accommodate several separate areas
Some say that as long as the concrete thickness exceeds 500, there is no need to use lead sheets?
The thickness of the wall should be related to the power of the flaw detector; there must be a calculation method for this, as it can’t be decided arbitrarily. Otherwise, it will be troublesome if the construction doesn’t pass the inspection after completion.