Thread Content
Are the technicians in charge of community water supply stations and small secondary water supply points tied up with \"pumps\" and \"water pressure\" every day? Fearing that the water pump might stop suddenly and leave residents without water ； Worried about unstable water pressure and water supply outages in high-rise buildings ； I have to make several trips a day to check the equipment, and I still need to go even when it’s windy or rainy. Not only is it tough work, but if a fault isn’t detected in time, residents keep complaining. Want to install surveillance cameras? It requires many devices, costs a lot of money, and you also need someone skilled in technology to set it up – it’s too much hassle. Stop being so tired! Hebei Blue Bee CLC-S22R Cloud Logic Controller: one device that helps you monitor water pumps and control water pressure; it can be managed via a smartphone, eliminating the need to visit the site daily – saving time and effort. 1. Know about pump failures early and reduce complaints from residents. The CLC-S22R can directly receive signals indicating the operation of the pump; if the pump stops working or there are abnormal currents, it immediately sends an alert to your phone – so you’ll be aware of the problem before residents even call to complain. It can also monitor water pressure; it sends an automatic alert when the pressure drops below 0.3 MPa, prompting prompt adjustment of the pump, so that residents in high-rise buildings will no longer experience water outages. Station Master Wang in Guangzhou is in charge of 3 community water supply stations. He used to make 3 trips per day, but once a pump broke down and wasn’t detected in time, which led to residents complaining to the property management. After installing the CLC-S22R, the phone alerts the technician when there is a problem, which reduced complaints by 90%; the number of visits to the site per day also dropped from 3 to 1. 2. There is no need to go to the site; parameters can be adjusted remotely. The pump parameters at water supply stations need to be adjusted from time to time, for example, to increase pressure during peak usage periods, and previously it was necessary to go to the site to turn the knobs. Now with the CLC-S22R, it’s possible to adjust the maximum water pressure and the timing for starting and stopping the pump right from the smartphone: just tap a few times at home before the peak usage period to increase the pressure ； Using less water in the middle of the night, and setting the pump to run intermittently remotely can also help save on electricity costs. The water supply station managed by Master Li in Henan is 5 kilometers away from his home; previously, he had to ride a bike there to adjust the parameters, taking 1 hour each way. Now it can be adjusted remotely; it takes just 1 minute. No need to go outside even in rain or snow. 3. It saves money and is durable; it’s affordable even for small locations. A set of traditional monitoring equipment costs over 3,000 yuan, while the CLC-S22R costs only a few hundred yuan. There’s no need to purchase additional gateways or sensors either – it can be used right after being plugged in. The equipment is of industrial grade; it won’t be damaged by freezing in winter or by the sun in summer, and it can be used for four to five years without any problems. It requires little maintenance over time, which saves a lot on repair costs. Whether you are managing 1 or 10 small water supply stations, the CLC-S22R can help you reduce the need to visit sites frequently, minimize complaints, and cut costs. Get a free installation plan to make water station management easier!