How to handle leaks in the methanol synthesis purification pipeline using low-temperature methanol washing
Thread Content
How to handle leaks in the methanol synthesis purification pipeline using low-temperature methanol washing
It’s the same; keep working without stopping, just clock in
This question is a bit vague; it depends on factors such as the amount of leakage, the exact location of the leak, and the cause behind it； Generally, if the amount of leakage is not large, it is only possible to seal the leak using a clamp while the system is under pressure ； ； Generally, leaks occur at the flange connections; leaks at the weld points are rarely seen
Determine the amount of leakage and its location; if it is at the flange, the gasket may be damaged – this depends on the situation. If the leakage cannot be controlled, the machine must be stopped for maintenance. If it is at a welded joint, flaw detection procedures must be carried out.