Discussion on gasification flushing water
Thread Content
We use the water-coal slurry process, and we want to know what the volume of water required for continuous flushing would be if we replace the drainage water with water used for continuous flushing How was it calculated?
It is not necessary to flush the coal slurry; after all, coal slurry only flows out when the coal slurry pipeline is flushed during shutdown. Therefore, there is no need for continuous flushing. The ditches surrounding the frame are circular as well, so continuous flushing is not required – regular cleaning is sufficient.
We want to use low-pressure graywater to flush the gutters; continuous flushing helps prevent pipeline blockages and also prevents freezing. I was wondering if the drain is flushed continuously, what methods are there to calculate the amount of water flushed per hour on a continuous basis
Generally, gutter flushing is done intermittently. We want to change our system to enable continuous flushing, and we were wondering if anyone knows how to calculate the water volume required for continuous gutter flushing?
In this case, the cross-sectional area of the gutter is calculated, and then multiplied by the flow velocity to obtain the flow rate; if it is necessary to continuously carry away the sediment, the flow rate calculated in this way may be quite high.
How to calculate it, and which quantities need to be counted? How to obtain those quantities
Why does the drain need to be flushed continuously? I can’t figure it out. When it is operating normally, there is no need to flush your pipes, and there is also no water in the gutters
Why does the drain need to be flushed continuously? I can’t figure it out. When it is operating normally, there is no need to flush your pipes, and there is also no water in the gutters