【Daily Question】Chemical Engineering Principles 174: Driers (September 16)
Thread Content
The last edit to this post was made by Zaihui Kangqiao on 2015-9-22 at 10:27. The Chemical Engineering Theory section is now launching a \"One Question per Day\" activity aimed at helping everyone reinforce their basic knowledge in chemical engineering. Subsequent series will include those on \"Principles of Chemical Engineering\", \"Mass Transfer and Separation\", \"Thermodynamics in Chemical Engineering\", and \"Chemical Process Engineering\". We hope for your active support! Answers to the questions in the \"One Question per Day\" activity can be viewed directly, and the thread will be closed after 1 day ! Participation earns 2 wealth points, with an additional 3 wealth points for correct answers. Fill-in-the-blank question: The temperature of the wet air leaving the dryer is _____ than the adiabatic saturation temperature. The purpose is _______. 20-50K voltage, prevents dried products from becoming damp again
The temperature of the wet air leaving the dryer is ____ higher than the adiabatic saturation temperature. The purpose is to ____prevent moisture from returning___.
The temperature t2 of the wet air leaving the dryer is 20–50 K higher than the adiabatic saturation temperature. The purpose is to prevent the dried product from becoming damp again
20---50 degrees high – the purpose is to prevent dried products from becoming damp again
Fill-in-the-blank: The temperature of the wet air leaving the dryer is 20-50 K higher than the adiabatic saturation temperature. The purpose is to prevent dried products from becoming damp again.
Keep the temperature at 20–50°C to prevent the dried products from absorbing moisture again
High, to prevent rehumidification. 1234567890
The temperature of the wet air leaving the dryer is ___ higher than the adiabatic saturation temperature __. The purpose is to __prevent dried products from becoming damp again____.
The temperature of the wet air leaving the dryer is __20-50 K__ higher than the adiabatic saturation temperature. The purpose is to ___prevent dried products from becoming damp again____
The temperature of the wet air leaving the dryer is __higher than__ the adiabatic saturation temperature. The purpose is to ___prevent the product from becoming damp____.
The temperature of the wet air leaving the dryer is 20–50°C higher than the adiabatic saturation temperature. The purpose is _to prevent dried products from becoming damp_______.