Warning
Thread Content
* WARNING: The streams that cross the loop and converge via $OLVER01 are not in mass balance: mass flow at the inlet = 0.13888889E+00, mass flow at the outlet = 0.13827700E+00; relative difference = 0.44251090E-02. This imbalance may be due to a large recycle flow and a relatively loose tolerance for tear streams. This problem has occurred in recent simulations; I really don’t know what to do – I’m seeking some constructive advice. Thank you!
This is just a warning, not an error; it indicates that there is a slight imbalance in the inflow and outflow of materials, but the difference is within an acceptable range. It seems that it says to reduce the circulating flow rate or lower the tolerance, but I guess an alarm will still be triggered. Did you set circular logistics to torn logistics?
Are the results usable? What matters is whether the result is available; if it is, the issue can be easily resolved, but if not, it’s a problem with the loop itself and the loop needs to be rewritten
It is usually caused by unreasonable data provided. Check data
If possible, send it over for me to take a look, if that’s feasible
When I open your PDF, it’s a corrupted file and I can’t view it; I’m using version 8.4
I’m sorry😊; mine is 8.6
In this case, how can I determine whether the data is available?
Has the original poster solved their problem? How was it done?
Faced the same situation – was the problem solved? How was it done? ? ?