Aspen beginner seeking advice on simulation tube expansion issues
Thread Content
As the title suggests, I need to determine the dimensions of a section of expanded pipe recently, namely its length and diameter. The purpose of expanding the pipe is to reduce the pressure of the water vapor and send it to the condenser for condensation. I was wondering if it is possible to use Aspen Plus or HYSYS to simulate such operating conditions and provide corresponding reference results? I asked for advice, thank you~
How can I do it? Could you give some advice? Thank you
I don’t see what’s wrong; just create a process simulation directly
Newcomers who are just learning the software don’t know how to set it up: Q:L:L
The diameter can be calculated, but what on earth is the length?
The 20 bar saturated steam is reduced in pressure to 2 bar before entering the condensation system; the peak flow rate of the saturated steam is 30 t/h, with intermittent exhaust.
Don’t we need to determine how long the pipe needs to be?
It turns out the pipe diameter is DN200. Thank you