Seeking help with the installation issue of Bentley 3500 software, urgent! ! !
Thread Content
I use a laptop to connect the 3500 software to the hardware via the RS232 interface; after uploading the program, I modify the parameters. Once the modified card is selected for download, I click the OK button. The message that appears is: “A management type monitor was detected in slot 4; you are downloading a non-management type monitor. Please reconfigure the monitor to management type.” Slot 4 contains a 40M card, and both the software version used is V3.93 as well as the hardware installed is a 40M card. Has anyone encountered this situation at work and knows how to resolve it? Thank you! !
A managed monitor was detected in slot 4; please download a non-managed one and configure it as a managed monitor.please. Is there a problem with the settings? ? Did the original poster change those parameters? ?
This post was last edited by budaoweng123 on 2016-4-28 at 19:16. The old cards used to have a capacity of 40, while the new cards have a capacity of 40M; the “M” here seems to stand for management. Set the configuration to 40 and see if it can be installed. If possible, it’s very likely that a refurbished item has been purchased.