Incomplete display in the small window and on the panel of the secondary screen in the Yokogawa DCS CENTUM VP dual-screen setup

Thread Content

The hard drive of the computer at the DCS operation station was damaged; a new hard drive was installed, the system and VP software were reinstalled. The installation and authorization processes proceeded normally. However, when in use, it was found that the sub-screen displaying the instrument panel, trends, and adjustment windows was incomplete – dragging the windows caused the screen to shift, and there was double imaging; such issues were not observed on the main screen. After switching between the primary and secondary screens, the same issue occurred on the original primary screen, while the original secondary screen worked normally. It seems that this is not related to hardware problems; it’s likely an issue with the software settings. The system has been reinstalled as well, and multi-window permissions have been set up again, but none of these methods have worked. I’m wondering if anyone else has encountered a similar problem and has some experience with it – please help! ! !