Could any expert in valve design please help?
Thread Content
This post was last edited by Wang Tianze on 2016-5-27 at 16:28. I am looking for a control valve to be used in oil fields, where the fluid being transported is crude oil containing fine sand and hydrogen sulfide. The temperature of the fluid is 80°C, the pressure is 250 MPa, and the pipe diameter is DN15. The flow rate range is (0.15~3) m3/h. I would like information on manufacturers or agents who can assist with design. Note: Email addresses are prohibited; thank you
When there is fine sand involved, it is necessary to consider the wear resistance of the material. It is recommended to choose well-known brands; in China, KOSO is a good option, while abroad, FISHER or Memmert are suitable choices, especially for high-pressure valves.
250MPa? That’s so scary?
If you have a data sheet, you can consult those manufacturers mentioned by 2#. If there is no data table, create one first, and then consult the main suppliers
25MPa,{:1_90:}
Present the requirements clearly to the manufacturer, and they will calculate it for you; they have software that makes the process very fast. :lol