Questions about compressors?
Thread Content
The inlet gas temperature of the material compressor C201 is 5°C, and the inlet gas pressure is 0.2 MPa. The required outlet pressure of the compressor is 3.7 MPa, with an outlet gas flow rate of 15.8 m3/min. The overall compression ratio is 3.7/0.2=19, with 5 stages of compression; what model of compressor should be chosen?
What is a medium? Is the flow the outlet condition flow?
A reciprocating compressor with three stages of compression can be used, or a twin-screw compressor； The gas flow rate and compression ratio of the centrifugal compressor do not meet the technical requirements
If you use 5-stage compression, then use a centrifugal compressor
Depending on your pressure and medium conditions, an MCL-type multi-stage centrifugal compressor can be used.
The media are C3H8, C3H6, H2, CH4, C2H4, C2H6, C2H2, H2O, mainly propylene and hydrogen. Well, it’s the outlet flow rate of the mixed gas
A reciprocating compressor with three-stage compression, of the 315Kw 4M6.5 model, can be used